Register Now


Lost Password

Lost your password? Please enter your email address. You will receive a link and will create a new password via email.

Can you put slate chippings on concrete?

Rate this Question and Answer
Asked By: Abdela Kartagener | Last Updated: 21st May, 2020
Easy to layslate chippings are a popular choice over tarmac, concrete and paving as they’re much simpler to lay. Reduce weed germination – a weed membrane can easily be laid beneath slate to block weeds emerging.

Also know, can you put chippings on concrete?

Yes, you can. Nidagravel gravel grids are the ideal way to stabilise gravel that is to be laid directly over concrete, tarmac and block paved driveways.

Also Know, can you put slate on top of soil? I enjoy growing dwarf conifers and the smaller variety of slate chippings make a perfect top dressing against the earthy tones of their ceramic pots. Using the chippings as a top dressing helps retain soil moisture for longer meaning that I don’t need to water them as much and also suppresses weeds.

Keeping this in view, can you put stones on top of concrete?

Pour PVA over the concrete and then (quickly) lay the gravel. Within minutes the stones will have bonded forever to the concrete and you will have a perfect gravel drive.

How do you stop stone chippings from moving?

Gravel should be raked up onto the driveway, and tamped down until it’s flat. Then the gravel should be wetted down with a hose, allowing the rock to shift and the dirt to accept the gravel once again. Don’t use too much water, because you might cause the driveway to shift and the dirt to run.

Can you lay self binding gravel on concrete?

SelfBinding Gravel is an easy to lay alternative to traditional materials such as flags, paving, macadam or concrete. The gravel binds together when rolled to provide a self compacted surface which remains firmer underfoot than conventional loose aggregate.

How do you cover an old concrete path?

Lay the field pavers over concrete as you would on any paver patio. Scrape away the excess sand and cut off the excess landscape fabric with a utility knife. Glue down the last border patio blocks. Let the glue dry for a few hours before you tamp the field pavers and sweep sand across the patio to fill the joints.

How do you lay pebbles on concrete?

Carefully place the wood float over one section of pebbles, tap the float up and down with the mallet to force the pebbles into the cement. Continue this along each step until all of the pebbles have been pushed in. Run your hand across the top to make sure they are all at even heights.

What can I cover concrete with?

Cover Your Concrete Patio – Ideas
  • Fake A Concrete Patio Cover Up With Stain.
  • How to Cover Your Patio with Paint and Make It look Like Tile.
  • Use Pavers to Cover Your Concrete Patio.
  • Use Tile To Cover a Concrete Patio.
  • Concrete Patio Idea – Cover Up with a Deck!
  • Another Concrete Patio Cover Up Using Stain.

What can you put on top of concrete?

Yes, you may pour a concrete pad overlay over an existing slab. You need to consider the added height and weight of the overlay on the existing structure. Overlays may include polymers, portland cement concrete, or epoxies.

Can I concrete over gravel?

Laying a concrete driveway over an existing gravel one is possible, but it is not generally recommended. However, if the gravel in your driveway is small enough, it is possible to create a cement driveway over the existing one.

Does concrete stick to concrete?

The key to successfully pouring concrete over an existing concrete surface is to ensure the two layers bond properly. Even though concrete is strong and forms a hard structure, there’s nothing in it that helps it stick to old concrete. A commercial bonding agent helps with that.

What kind of mortar do you use for flagstone?

Thinset mortar is the same type of mortar that is used in traditional ceramic tile installations. It is a combination of sand, cement and polymers. You can trowel it on using a notched trowel with a size that is dependent on the size of the flagstone with which you are working.

How do you dig up paving slabs?

Use the sledge hammer near the pry bar tip to break off more of the concrete. Remove rubble, and continue these steps, with the pry bar tip moving with the removable concrete slab edge. Progress at this point will feel slow, but stick with it. Keep removing the rubble, and using the pry bar and sledge hammer in tandem.

Can you lay a patio on concrete?

According to several paver manufacturers, paving blocks can be installed on top of concrete without mortar if you first lay down a 1/2″ to 1” bed of coarse sand. Drainage: The biggest problem with laying pavers over a concrete slab is the inability for water to drain through the blocks and down into the earth.

How do you lay slate chippings on soil?

Mark out where your slate chippings need to be laid using something like string or rope. Dig out the area to approximately 4 inches deep. Then, rake the base of the area and compact it using a flattening tool. At this point you may wish to add a border, keeping the slate neatly contained.

How do you prepare ground for chippings?

Ground preparation
  1. Clear the space of all vegetation.
  2. Remove weeds and carefully take out plants you want to keep and introduce back into your gravel garden.
  3. Dig over the ground once or twice to enhance the condition of the top layer of soil.
  4. Rake well to even out the surface and break down any lumps and bumps.

How do you make a slate garden border?

Lay the entire first row of slate stones in the trench. If you prefer a mortared wall border, then mix a batch of mortar in a bucket, following the mortar mix’s package directions. Lay a few slate stones 1/2 inch apart on the gravel in the trench, and spread a 1/2-inch-thick layer of mortar between those stones’ ends.

How much does a bulk bag of slate chippings cover?

8 bags = 1m2 approx. 1 Bulk Bag (850kg) = 10m2 approx. 1 Bulk Bag (850kg) = 5m2 approx.

How much does a ton of slate cover?

Blue Slate 40mm Tonne Bag. Coverage: 1000kg of 40mm blue slate will usually cover about 12m² (12m x 1m) at a depth of about 40mm. Consists Of: 40mm slate chippings. Usage: Decorative slate is an ideal garden brightener, popular for use on borders and driveways.

How many bags of slate chippings do I need?

We estimate an area of 5 metres by 5 metres, with a depth of 40mm, would require approximately three bulk bags of aggregates, slate chippings or gravel.

What do you put under stones in garden?

Put down a weed mat.
  1. The base covering that will be covered by the weed mat can be soil, sand, grass, pavement or other natural material.
  2. The weed mat will limit the growth of weeds coming up through the pebbles.
  3. Weed mats can be purchased in a garden or landscaping store.

  • 12
  • 39
  • 39
  • 39
  • 24
  • 29
  • 39
  • 14
  • 33
  • 26